Skyjack SJ85AJ User Manual

208932AEA SJ85AJ
16
Section 2 – Operator Safety Fall Protection
DO NOT use the MEWP without guardrails, locking
pins and the entry gate/drop bar in place.
DO NOT exceed the rated
capacity of the MEWP.
DO NOT distribute load
unevenly.
DO NOT use under inuence of
alcohol or drugs, or if operator’s
performance is impaired by a
medical condition, the inuence
of prescription or over the counter
drugs, or fatigue.
DO NOT attempt to free a snagged platform with
lower controls until personnel are removed from the
platform.
DO NOT position the MEWP against another object
to steady the platform.
DO NOT operate on slippery surfaces not capable
of providing adequate traction to stop, drive or steer
the MEWP.
DO NOT place materials on the guardrails or
materials that exceed the connes of the guardrails
unless approved by Skyjack.
DO NOT operate if MEWP is not
working properly or if any parts
are damaged or worn.
DO NOT leave MEWP
unattended with key in key
switch.
2.3 Fall Protection
Skyjack recommends the use of a fall restraint system
to keep an occupant within the connes of the
platform, and thus not expose the occupant to any fall
hazard requiring a fall arrest.
WARNING
Failure to wear personal fall protection equipment
may result in death or serious injury.
All personal fall protection equipment must comply
with applicable governmental regulations and must
be inspected and used in accordance with the
manufacturer’s recommendations.
All personal fall protection equipment must be
attached only to approved anchorage points within
the platform of the MEWP.
WARNING
Entering and exiting the MEWP should only be
done using the three points of contact.
▪
Use only equipped access openings.
▪
Enter and exit only when the MEWP is in the
fully retracted position.
▪
Do use three points of contact to enter and exit
the platform. Enter and exit the platform from the
ground only. Face the MEWP when entering or
exiting the platform.
▪
Three points of contact means that two hands
and one foot or one hand and two feet are in
contact with the MEWP or the ground at all
times during entering and exiting.
WARNING
An operator should not use any MEWP that:
▪
does not appear to be working properly.
▪
has been damaged or appears to have worn
or missing parts.
▪
has alterations or modications not approved
by the manufacturer.
▪
has safety devices which have been altered or
disabled.
▪
has been tagged or locked out for non-use or
repair.
Failure to avoid these hazards could result in death
or serious injury.

Skyjack SJ85AJ Specifications

General

Brand	Skyjack
Model	SJ85AJ
Category	Lifting Systems
Language	English