7
SAFETY ADVISORY
This guide includes important instructions about safe espresso machine
installation, operation, and maintenance. Read this manual completely
before installing and operating your Slayer espresso machine. Incorrect
installation and operation may result in damage to the equipment,
personal injury, or even death. Disregarding the instructions contained
herein indemnifies Slayer from all resulting damages and may void the
machine’s warranty.
Shipping is coordinated by the customer and performed by a third party.
Slayer is not responsible for damage incurred during transport. Upon
receiving your machine, carefully inspect all packaging, equipment,
and accessories for visible damage. Photograph any visible damage to
the crate or espresso machine and immediately contact your shipping
company representative within seven days of receipt. Comply with
shipping company regulations. Do not connect your machine to power,
water, or drainage until all issues have been resolved or your Slayer
representative or reseller instructs you to do so. Failure to resolve issues
before using equipment may result in further damage or injury.
Installation should be performed by qualified personnel only and must
comply with all regulations and requirements of the authorities in your
area. If guidance is needed to safely install your machine, contact your
Slayer representative or reseller.
It is critical that an appropriately-rated and grounded electrical plug is
used to supply your machine with power. This is essential for the safe
operation and use of the equipment. Contact your Slayer representative
or reseller with questions about this requirement. If you are unsure about
the safety of the electrical configuration, do not attempt to install your
machine.
Your Slayer espresso machine should only be used for the functions it
was designed to perform. Using your machine outside of its defined
functionality – as it is described in the “Using Slayer” section on pg. 17 of
this guide – may be a safety hazard, resulting in property damage, physical
injury, or even death, and will immediately void the warranty.
Slayer espresso machines are electrical appliances that should be used in
a safe manner appropriate to devices of their kind:
• Do not connect your Slayer espresso machine to electrical power
through an extension cord. The machine must be directly connected
to an appropriately - rated and grounded power source.
• Do not position the power cord in walkways or other high-trac areas.
• Slayer espresso machines are designed to be used indoors. When
using your machine outdoors, take precautionary measures to protect
it from moisture, humidity, and other natural elements.
• Before performing service on your machine, disconnect the
power source and turn o the water feed.
• Prior to installation, make sure there is a circuit breaker installed
with a distance between the contacts that allows for complete
disconnection when there is a category III overload and that provides
protection against current leakage equal to 30 mA. The circuit breaker
must be installed on the power-supply in compliance with installation
rules. If the power-supply is not working properly, the appliance can
cause transitory voltage drops. The electrical safety of this appliance
is only ensured when it is correctly connected to an ecient earthing
system in compliance with the electrical safety laws in force. This
fundamental safety requirement must be verifed. If in doubt, request
that a qualified electrician inspect the system. The manufacturer
cannot be held responsible for any damage caused by the lack of an
earthing system on the electrical supply.
Please also observe the following rules for installation and operation:
• Room temperature must range between 10° and 32°C (50°F and
90°F)
• Do not install in rooms (kitchens) that are cleaned with jets of water
or attempt to clean the machine with jets of water
• When to water mains, only use the supplied parts for installation. If
other parts are installed, they must be new (unused pipes and gaskets
for the water connection) and they must be permitted for contact
with water suitable for human consumption (according to local laws
in force)
• The mains water pressure connection should be between a minimum
of 300 kPa (3 bar) and a maximum of 500 kPa (5 bar)
SLAYER STEAM X USER MANUAL V1.1 | SEPTEMBER 2019
To Next Page
Loading...
Need help?
General
