SLAYER STEAM EP USER MANUAL V1.1 | SEPTEMBER 11, 2018 16
STEP 6: TURN ON ELEMENTS
PROCEDURE
1. Ensure that all brew activation buttons are “OFF” (not lit or blinking),
the cup tray panels have been removed, and the tanks have filled
completely (per previous steps)
2. Turn on the heating elements by moving the heating element breaker
left, to the “on” position.
Do not move the steam actuators to the “on” position as the
machine will automatically cycle the valves during initial heat up.
3. Wait until the machine has heated fully and the pressure reads 1+
bars on the Barista Dashboard, then move one of the steam actuators
down, to the “On” position. If steam is produced, proceed to the next
step. If no steam is produced, turn the main power On and O; wait
several minutes before repeating this step.
4. Check the inside of the machine for leaks or collected water.
The anti-suction valve on the steam tank may sputter and
release small drops of water when first building pressure. During
your inspection, check for large pools or steady streams of
water.
5. Install the four (4) cup tray panels.
To Next Page
