Slayer STEAM EP - Other Menu Options

SLAYER STEAM EP USER MANUAL V1.1 | SEPTEMBER 11, 2018 40
OTHER MENU ACTIONS
Through the Advanced Menu, you may access additional settings. Do
not interact with the Advanced Menu before reading this manual in its
entirety, then – if unsure – consulting your Slayer representative, reseller,
or qualified service personnel.
From the idle screen, access the Advanced Menu by pressing and holding
the jog wheel, until a beep sounds. At any time, you may press and hold
the jog wheel or move the actuator Left to Right to save your new settings
and exit the menu.
HEATER CONTROL ELEMENT ON/OFF
1. Press and hold the jog wheel above the left group head for five
seconds to activate the Advanced Menu options. Press and release
the jog wheel to enter the “Heater Control” setting. The option to
adjust all heating elements, universally, will be presented.
2. Rotate the jog wheel to cycle between “On” and “O”.
3. Press and release the jog wheel to confirm your new setting and
proceed to the next step.
4. Repeat steps 4-5 for all remaining settings:
• Gp1 (heating element for leftmost brew tank)
• Gp2 (on 2-group, right brew tank; on 3-group, middle brew tank)
• Gp3 (rightmost brew tank; 3-group only)
• Stm (steam tank)
TEMPERATURE CHOOSE C OR F
1. Press and hold the jog wheel above the left group head for five
seconds to activate the Advanced Menu options.
2. Rotate the jog wheel clockwise until the “Temperature” setting
appears.
3. Press and release the jog wheel to enter the “Temperature” setting.
The option to adjust the unit of temperature measurement will be
presented.
4. Rotate the jog wheel to cycle between “C” (Fahrenheit) and “F”
(Celsius).
5. Press and release the jog wheel to confirm your new setting and return
to the menu for additional adjustments OR move the brew actuator
Left to Right to save and exit the Advanced Menu.
SET LANGUAGE
1. Press and hold the jog wheel above the left group head for five
seconds to activate the Advanced Menu options.
2. Rotate the jog wheel clockwise until the “Language” setting
appears.
3. Press and release the jog wheel to enter the “Language” setting
4. Scroll to select your desired Language.
5. Press and release the jog wheel to cofirmn your language and return to
the menu for additional adjustments OR move the brew actuator Left
to Right to save and exit the Advanced Menu.