SLAYER STEAM EP USER MANUAL V1.1 | SEPTEMBER 11, 2018 33
LIFETIME COUNT (SHOT COUNTER)
A non-resettable number displays the total count of shots extracted over
the lifetime of the machine, per group head (and not individual button
counts). Scrolling through this menu will showcase the full shot counts
per group for all programmable volumetrics. A shot is not recorded if the
button is turned On and O within 5 seconds of being activated, excluding
the group purge or rinse from the total value. To successfully view your
shot counts to date use the details listed below. The hot water tap total
count is also visible in this menu.
1. Scroll to the Passwords title screen in the Home menu, select and
enter the correct PW for the Advanced Menu.
2. Turn the menu button clockwise to Lifetime Count enter the menu by
depressing the button.
3. Scroll through the menu to read the number of shots extracted on
each group.
SCREEN EXAMPLE:
Lifetime Count
<Gp2:> 973
4. Scroll to see the number of times the Hot Water Tap button has been
engaged
SCREEN EXAMPLE:
Lifetime Count
<H2O> 550
5. Long press (5 sec.) and hold to exit the Home Menu, short press (2
sec.) to continue working in the Advanced menu program platform.
SET TIME/DATE
Setting time and date is critical in order to utilize Power Save mode and
to enact your countdown to service clock. Use the following steps to set
Time and Date.
1. Scroll to Passwords, enter your password for the Advanced
Menu
2. Rotate the jog wheel clockwise until the “Set Time/ Day” setting
appears.
3. Press and release the jog wheel to enter the “Set Time/ Day” setting.
The option to adjust the clock type will be presented.
4. Rotate the jog wheel to cycle between “12H” (12-hour clock) and
“24H” (24-hour clock).
5. Press and release the jog wheel to confirm your new setting and
proceed to the next step. The option to adjust the hour will be
presented.
6. Rotate the jog wheel to adjust the hour.
7. Press and release the jog wheel to confirm your new setting and
proceed to the next step.
8. Repeat steps 6-7 for all remaining settings:
• Min (minute)
• Day
9. Long press and hold the program button save and exit the menu
Time/Day must be programmed before you can move onto setting up
Power Save options.
TIMES FOR POWER SAVE TO BEGIN/ END
REMINDER: Time and date must be set in advance to proceed with the
setup of Powersave mode. Power-save settings can be set to all days or
individual daily schedules if hours of operation change from weekday to
weekend schedules. When power-save is “OFF”, all systems are normal.
When power-save is “ON”, the machine is in sleep mode.
When the machine is in power save mode the resting values are as
follows:
• Steam pressure is reduced to 0.3 bars
• Brew temperatures are reduced to 100.0° F (37.7 C)
All systems begin heating for normal operation thirty (30) minutes before
power- save is scheduled “OFF”.
Set: Power Save Begin
1. From the Home menu, scroll to Passwords and enter the Advanced
menu password.
2. Rotate the menu button clockwise until the “Times For Power Save To
Begin” title screen appears, press to enter.
3. Set the time.
SCREEN EXAMPLE:
Power Save Begin
<Mon> <07>:00 P
(Example times displayed, set accordingly)
4. Choose to Copy ALL days <YES> or <NO> and set individual times for
power save to begin if closing times vary day to day.
To Next Page
Loading...
