SMA Sunny Island 2012 - Sunny Remote Control 1

SMA Sunny Island 2012

212 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

SMA Solar Technology AG Unpacking

Technical Description SI2012_2224-TEN082311 21

4.2.2 Sunny Remote Control 1

You can identify the display by the name plate. The type plate is located on the rear side of the

Sunny Remote Control 1.

.

Table of Contents

Default Chapter3
- Table of Contents3
1 Notes on this Manual9
- Validity9
- Target Group10
- Storage of the Documentation10
- Explanation of the Symbols Used10
  - Syntax11
2 System Overview12
3 Safety Instructions16
4 Unpacking17
- Scope of Delivery18
- Sunny Island 2012/222418
- Sunny Remote Control 119
- Name Plate/Firmware Version20
- Sunny Island 2012/222420
- Sunny Remote Control 121
5 Installation22
- Required Tools and Resources22
- Sunny Island 2012/222423
- Dimensions23
- Choosing a Mounting Location24
- Observe Minimum Clearances25
- Mounting Position26
- Mounting the Sunny Island with a Wall Mounting Bracket27
- Sunny Remote Control 131
- Dimensions31
- Choosing a Mounting Location31
- Wall Mounting32
- Installing Batteries33
6 Opening and Closing36
- Opening the Sunny Island37
- Closing the Sunny Island38
7 Sunny Island Electrical Connection39
- At a Glance40
- DC Connection43
- Grounding43
- Connecting the Battery44
- Connecting the Sunny Island45
- AC Connection46
- Grounding47
- AC1 (Loads/Sunny Boys)48
- AC2 (Gen/Grid)50
- Sunny Remote Control 151
- Communication53
- Communication with Sunny Island53
- Communication with External Devices56
- Additional Connections59
- Battery Temperature Sensor59
- Battery Current Sensor61
- Multi-Function Relays 1 and 263
- Batvtgout Power Supply66
- Digin Digital Input66
- Configuring a System with Several Sunny Islands68
- Concluding Tasks69
8 Control Elements70
- Sunny Island70
- Control Panel on the Enclosure70
- Control Panel Buttons70
- Meaning of the Light-Emitting Diodes (Leds)70
- Sunny Remote Control 172
- Display Messages73
- Key73
- Rotating Pushbutton74
- MMC/SD Card74
9 First) Commissioning75
- Requirements75
- Starting the Quick Configuration Guide (QCG)76
- Commissioning the Battery Current Sensor81
10 Operating the Sunny Island83
- Switching on and off83
- Switching On/Starting83
- Stopping85
- Switching off87
- Disconnecting the Device from Voltage Sources87
- Restarting the System after Automatic Shutdown88
- Navigation Area89
- Standard View 192
- Standard View 293
- Select Menu97
- Selecting Parameters99
- Selecting Events99
- Selecting Warnings and Faults100
- Making Adjustments101
- Adjusting Parameters101
- Setting the Installer Password102
- Accessing Parameters Directly105
- Meter Compact105
- Saving Data Onto a MMC/SD Card107
- Inserting the Card111
- Removing the Card112
- Loading and Saving Parameters112
- Writing Log Data113
- Show Status113
- Updating Firmware114
11 Additional Functions117
- Load Shedding117
- Sleep Mode118
- Search Mode118
- Time-Controlled Operation119
- Overload and Short Circuit Behavior119
- Device Failure and Autostart119
12 Battery Management120
- Battery Temperature120
- Start Options121
- Charge State/Soc and SOH121
- Charge Control122
- Boost Charge124
- Full Charge124
- Equalization Charge126
- Manual Equalization Charge127
- Silent Mode127
- Battery Preservation Mode127
- Battery Diagnostics129
13 Connecting External Sources130
- Generator130
- Connecting Generator Connections in Parallel131
- Generator Start Options131
- Generator Operation135
- Manual Generator Operation135
- Automatic Generator Operation137
- Limits and Power Adjustment141
- Run Times143
- Operation Together with Sunny Boys144
- Stopping the Generator145
- Failures146
- Grid146
- Conditions147
- Stand-Alone Grid Operation147
- Grid Reconnection147
- Grid Operation148
- Grid Failure149
- Failures149
- Limits and Power Adjustment149
- Operation Together with Sunny Boys150
- Generator and Grid151
14 Relay152
15 Sunny Boy in the Island Grid System154
- Setting the Stand-Alone Grid Parameters154
- Frequency Shift Power Control (FSPC)156
16 Maintenance and Care158
- Enclosure158
- The Sunny Island's Control Panel158
- Sunny Remote Control 1158
- Functional Test158
- Battery159
- Disposal159
17 Parameter List Overview160
- Display Values162
- Adjustable System Parameters166
- Diagnosis178
- Events, Warnings and Failures (History)182
- Functions During Operation182
18 Troubleshooting/Problem Solving184
- Error Confirmation184
- Handling Autostart184
- Handling Failures Present During Startup184
- Display of Failures and Events184
- Events185
- Error Categories188
- Warnings and Failure Messages188
- Troubleshooting192
19 Optional Devices195
- External DC Fuse195
- External DC Charge Controllers (Optional)195
- Accessories (Optional)195
- SMA Products (Optional)196
20 Technical Data197
- Sunny Island 2012/2224197
- Sunny Remote Control 1200
21 Contact201
22 Glossary202

Related product manuals

Preview: SMA Sunny Island 5048

SMA Sunny Island 5048

Preview: SMA SUNNY ISLAND 6.0H

SMA SUNNY ISLAND 6.0H

Preview: SMA SUNNY ISLAND 3.0M

SMA SUNNY ISLAND 3.0M

Preview: SMA Sunny Island 4548-US

SMA Sunny Island 4548-US

Preview: SMA SUNNY ISLAND 6048-US

SMA SUNNY ISLAND 6048-US

Preview: SMA SUNNY BOY 3300

SMA SUNNY BOY 3300

Preview: SMA SUNNY BOY 5000

SMA SUNNY BOY 5000

Preview: SMA SUNNY BOY 2000HF

SMA SUNNY BOY 2000HF

Preview: SMA SUNNY BOY 5000TL

SMA SUNNY BOY 5000TL

Preview: SMA Sunny Boy 6000US

SMA Sunny Boy 6000US

Preview: SMA SUNNY BOY 3000TL

SMA SUNNY BOY 3000TL

Preview: SMA SUNNY BOY 1600TL

SMA SUNNY BOY 1600TL