SMA Sunny Island 2012 - Selecting Parameters; Selecting Events

SMA Solar Technology AG Operating the Sunny Island
Technical Description SI2012_2224-TEN082311 99
10.2.4 Selecting Parameters
Parameters are shown on the display as follows:
• To the left are the menu number and the
parameter number. To the right, a bar
shows the status of the value queried at
present.
• To the left is the parameter name and to the
right the "enter" arrow . The arrow
indicates that this parameter can be
adjusted.
• Magnitude and units.
10.2.5 Selecting Events
The event list is found in the main menu, under 400# Failure/Event. Then go to the submenu 1 and
activate 430# Event.
Events are shown on the display as follows:
• To the left are the menu number and name.
To the right is the total number of events.
• Date and time of the event.
• Event and number (see chapter 18.5
"Events" (Page 185)).
• Description of the event
Syntax for this document
The syntax specified here for menus and parameters applies throughout the entire
document.
A menu is marked by a hash mark, menu number and menu names
(130# Meter Backup).
A parameter is marked with a menu number, dot (hash, on the display), parameter
number and parameter name (131.01 TotExtPwrAt).
210#01 ¿
InvVtgNom 
230.0 [V]
430# Event 001
2007-04-17 11:55:01
E101 ---
Silent