SMA Solar Technology AG Installation
Technical Description SI2012_2224-TEN082311 25
5.2.3 Observe minimum clearances
The following minimum clearances to walls, other devices or objects must be observed to guarantee
sufficient heat dissipation.
All external cables are connected through the
underside of the housing. This requires a minimum
clearance of at least 50 cm.
Direction Minimum clearance
sides 10 cm
above 30 cm
below 50 cm
in front 5 cm
Sufficient Ventilation
When installing the in smaller rooms, make sure that adequate ventilation is available.
During operation the device produces heat which must be dissipated.
To Next Page
Loading...
