SMA Sunny Island 2012 - 6.1 Opening the Sunny Island

SMA Solar Technology AG Opening and Closing
Technical Description SI2012_2224-TEN082311 37
6.1 Opening the Sunny Island
1. Loosen the six non-removable allen screws on the
lower cover (B).
2. Remove the cover carefully.
3. Unplug the control area cable from the inner side
of the enclosure cover (in the new devices the
cable is not in place).
4. Keep the cover in a safe place.
NOTICE!
The components in the Sunny Island (e.g., communications interface) can be
damaged by an electrostatic discharge!
• When working on the Sunny Island and when handling the components observe all
ESD safety regulations.
• Eliminate static charge by touching the grounded metal casing.
• Only then should you begin any work.
B
D