Operating the Sunny Island SMA Solar Technology AG
86 SI2012_2224-TEN082311 Technical Description
Stopping the system with Sunny Remote Control 1
Set the Sunny Island to standby using the external display.
Proceed as follows:
1. Press and hold the pushbutton on the Sunny
Remote Control 1.
The following display appears:
2. Hold the pushbutton as long as the remaining
time for the stop process is shown on the display
as bars.
3. The display changes
4. Let go of the pushbutton.
5. The Sunny Island has stopped.
DANGER!
Death hazard due to high voltages
The island grid system is in "standby" operating modus!
• Do not open the device!
• Do not work on the island grid system!
There are still voltages present on the Sunny Island (DC and AC sides).
• Switch off the Sunny Island
• Disconnecting the Sunny Island from Voltage Sources
Consumption in standby mode
In standby mode the Sunny Island still requires about 6 W of power from the batteries.
Hold to stop...
¿¿¿¿¿¿¿¿¿¿¿¿¿¿¿¿
STNDBY: To Start
INV hold <Enter>
To Next Page
Loading...
