Operating the Sunny Island SMA Solar Technology AG
96 SI2012_2224-TEN082311 Technical Description
The display changes
The generator status and the reason for its deployment are shown (alternating)
under "Generator-Status" in the display.
• If, for example, the display changes every 3 seconds from "*" to "B", this
means that the generator voltage and frequency lie within the specified limits
and that the generator was requested as a result of the battery charge level.
• If the generator has been manually set to "Stop", then no generator status
information is shown on the display. The field remains empty.
6. Relays
= relay activated
o = relay deactivated
7. Warning:
! = Warning
The symbol blinks until you have seen and cleared the warning in menu "410# Fail
Current" or "420# Fail History".
Faults: If there is a fault, the device goes into standby. A fault notice appears on the
display. Acknowledge and clear the fault; then the Sunny Island can be restarted.
Change to Standard View 1
The display switches to standard view 1 (home screen) automatically if the Sunny Remote
Control 1 has not been used for more than five minutes (inactivity).
Display Illumination
The background illumination is automatically deactivated after a short time of inactivity.
Switch the lighting back on by turning the pushbutton slightly. This turning changes no
settings; it only reactivates the display illumination.
Message Displays
Messages are displayed at all times during operation, they have priority over the
standard view 1 (home screen).
To Next Page
Loading...
