Page 37

SMAC CBC-EIP - Page 37

46 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Image 11

Image 12

Table of Contents

Table of Contents3
Introduction5
Hardware7
- Power/Signal/Communication Connectors7
- I/O and STO Electrical Schematics8
- Disabling the STO (OPTIONAL)10
- Fully Independent STO Channels11
- STO Feedback Output11
- STO Abnormal Operation12
Setup Guide7
Software14
- Basic Drive Configuration of CBC-EIP14
- Modification of IP (Internet Protocol) Settings15
- Explicit Messaging15
- Implicit (IO) Messaging16
- Add-On Instructions (AOI) for Studio5000/Rslogix5000 PLC Software17
Position Move17
Softland Move19
Homing Move21
Velocity Move23
Force Move24
SMAC Fault Status25
- Performing Fault Reset25
SMAC Motor Halt28
SMAC Motor on29
SMAC Motor off30
Motor Quick Stop31
Allen Bradley PLC with SMAC CBC-EIP Drives32
Step by Step Software Setup32
Any PLC with SMAC CBC-EIP Drives38
Firmware Update and PDO Parameter Setup39
- Regular Update40
- Forced Update41
- PDO Parameter Setup41
Common Software Troubleshooting45
- IP Address Alterations45

EasyManua.ls – Your Ultimate Manuals Destination!

With a comprehensive collection of over 1 million PDF manuals, service guides, instruction booklets, and quick start guides, we cover every aspect of your needs. Explore manuals for products from more than 50,000 brands all in one place. Search and instantly view the manual you’re looking online for free.

Privacy Policy
Contact Us

© Copyright 2025 EasyManua.ls. All Rights Reserved.