SMART Board 6000S Series User Manual

Chapter 5
Troubleshooting
smarttech.com/kb/171415 58
Touch isn’t working as expected
Symptom Troubleshooting steps
The display doesn’t respond to touch.
l
Make sure SMART Product Drivers are installed and running on connected computers.
(SMART Board 6000S (V3) models displays require SMART Product Drivers 12.18 or
later, and SMART Board 6000S (C) and 6000S model displays require SMART Product
Drivers 12.14 or later).
l
Make sure the USB cable between the display and the computer doesn’t exceed the
supported maximum cable length. See Using recommended cables on page51.
l
Make sure any connected computers have detected the display’s USB connection.
l
On Windows computers, open Device Manager and make sure there is no red X or
yellow explanation mark (!) over the display’s icon.
l
On Mac computers, open System Information and make sure there are no error
messages in the display’s row.
l
For Mac computers with macOS Mojave, see How to resolve issues with installing and
using SMARTLearning Suite software on macOS Mojave.
The display responds to touch
intermittently.
OR
When you touch the screen, the
pointer doesn’t appear in the correct
place.
l
Restart the display.
l
Make sure SMART Product Drivers and SMARTInk are installed and running on any
connected computers.
l
Confirm with the installers that the computer is connected to the display with only a
single cable.
l
Remove infrared sources, such as incandescent or arc lights, desk lamps, and infrared
audio devices, or move the display to another location in the room.
l
Remove any USB extenders to help isolate the USB cable.
l
Update the firmware.
The pens and erasers aren’t working as expected
Symptom Troubleshooting steps
The display doesn’t respond to touch
or writing with a pen.
l
Make sure SMART Product Drivers are installed and running on connected computers.
(SMART Board 6000S (V3) models displays require SMART Product Drivers 12.18 or
later, and SMART Board 6000S (C) and 6000S model displays require SMART Product
Drivers 12.14 or later).
l
Make sure any connected computers have detected the display’s USB connection.
l
On Windows computers, open Device Manager and make sure there is no red X or
yellow explanation mark (!) over the display’s icon.
l
On Mac computers, open System Information and make sure there are no error
messages in the display’s row.
l
Reinstall or update SMART Product Drivers and SMARTInk on any connected
computers.

SMART Board 6000S Series Specifications

General

Resolution	4K UHD (3840 x 2160)
Screen Sizes	65", 75", 86"
Aspect Ratio	16:9
Touch Points	20
Brightness	350 cd/m²
Contrast Ratio	4000:1
Response Time	8 ms
Wall Mountable	Yes
Connectivity	HDMI, USB, VGA, DisplayPort
Operating System	Android