Smartgen HGM9520N - Perkins; Scania; Volvo Edc3

HGM9520N Genset Paralleled Controller User Manual Page 108 of 111
17.13 PERKINS
It is suitable for ADEM3/ADEM4 engine control module. Engine type is 2306, 2506, 1106, and 2806.
Table 40 Connector
Terminals of controller
Connector
Remark
Fuel relay output
1, 10, 15, 33, 34
Starting relay output
-
Connected to starter coil directly.
CAN GND
-
CAN communication shielding line
(connected with controller terminal only).
CAN(H)
31
Using impedance 120Ω connecting line.
CAN(L)
32
Using impedance 120Ω connecting line.
Engine type: Perkins.
17.14 SCANIA
It is suitable for S6 engine control module. Engine type is DC9, DC12, and DC16.
Table 41 B1 Connector
Terminals of controller
B1 connector
Remark
Fuel relay output
3
Starting relay output
-
Connected to starter coil directly.
CAN GND
-
CAN communication shielding line
(connected with controller’s terminal only).
CAN(H)
9
Using impedance 120Ω connecting line.
CAN(L)
10
Using impedance 120Ω connecting line.
Engine type: Scania.
17.15 VOLVO EDC3
Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Table 42 “Stand Alone” Connector
Terminals of controller
“Stand alone” connector
Remark
Fuel relay output
H
Starting relay output
E
Auxiliary output 1
P
ECU power;
Set output 1 as “ECU power”.
Table 43 “Data Bus” Connector
Terminals of controller
“Data bus” connector
Remark
CAN GND
-
CAN communication shielding line
(connected with controller’s terminal only).
CAN(H)
1
Using impedance 120Ω connecting line.
CAN(L)
2
Using impedance 120Ω connecting line.
Engine type: Volvo.