Smartgen HGM9520N - Selection of Sensors

HGM9520N Genset Paralleled Controller User Manual Page 88 of 111
7.4 SELECTION OF SENSORS
Table 19 Sensor Selection
No.
Description
Remark
1
Temperature Sensor
0 Not used
1 Custom Res Curve
2 Custom (4-20)mA curve
3 Custom (0-5)V curve
4 VDO
5 CURTIS
6 DATCON
7 SGX
8 SGD
9 SGH
10 PT100
11 SUSUKI
12 PRO
13-15 Reserved
Defined resistance’s range is
(0~6)kΩ.
2
Pressure Sensor
0 Not used
1 Custom Res Curve
2 Custom (4-20)mA curve
3 Custom (0-5)V curve
4 VDO 10Bar
5 CURTIS
6 DATCON 10Bar
7 SGX
8 SGD
9 SGH
10 VDO 5Bar
11 DATCON 5Bar
12 DATCON 7Bar
13 SUSUKI
14 PRO
15 Reserved
Defined resistance’s range is
(0~6)kΩ.
3
Level Sensor
0 Not used
1 Custom Res Curve
2 Custom (4-20)mA curve
3 Custom (0-5)V curve
4 SGD
5 SGH
6~15 Reserved
Defined resistance’s range is
(0~6)kΩ.
NOTE: User should make special declare at ordering controller if your engine temperature sensor, fuel level sensor or
flexible sensor 2 uses non-resistance sensor.