HGM9520N Genset Paralleled Controller User Manual Page 6 of 111
1 OVERVIEW
HGM9520N genset paralleled (with Mains) controller is suitable for manual/auto parallel system of
single genset and Mains, to realize automatic start/stop, parallel running, data measurement, alarm
protection as well as “3 remotes” functions. It fits with large LCD display, optional Chinese, English and
other languages interface, and it is reliable and easy to use.
HGM9520N genset paralleled (with Mains) controller has GOV and AVR control function, providing
various modes of running in parallel with Mains. For example, genset constant active power and
inactive power/power factor outputs, Mains peak clipping function, which can recover to Mains supply
function continuously. Controller can precisely monitor all running status of genset, and when abnormal
occasions occur, genset can parallel off, and stop the genset, in which process, fault status will be
displayed on the LCD. Controller has SAE J1939 port, and can communicate with various ECU (Engine
Control Unit) with J1939.
HGM9520N genset paralleled (with Mains) controller applies 32-bit micro-processor technology,
which realizes precise measurement of many parameters, value adjusting and timing, threshold setting
functions etc. Majority of parameters can be adjusted from controller front panel, and all parameters
can be set by USB port on PC, moreover they can be adjusted and monitored by RS485 or ETHERNET on
PC. It can be widely used in various types of automatic gen-set parallel system with compact structure,
simple connections and high reliability.
To Next Page
Loading...
Need help?
General
