of the record being searched. Click Enter to access playback screen. Click Playback
button directly to perform Accurate Playback of the record searched;
Zoom In: When performing single-screen full screen playback, left click the mouse to select any
area on the screen. Left click the mouse again within the selected area to playback in zoom-in mode.
Right click the mouse to exit zoom-in.
3.5.3 Recording Control
Control recording on each channel. Highlighted “●” indicates the current recording status of the
channel. Playback page is accessible by either using desktop quick launch or entering 【Right Click】>
【Recor mode】.
Figure 3.8 Recording Control
【Schedule】Record in accordance with the configuration parameters；
【Manual】Regardless of the current status of the channel, selecting “Manual” will start the recording
on the corresponding channel；
【STOP】Regardless of the current status of the channel, selecting “STOP” will stop the recording on
the corresponding channel；
3.5.4 PTZ Control
Control Pan/Tilt/Zoom connected to the device. Use desktop quick launch to enter the menu.
Control interface is shown as in Figure 3.10. Functions supported: Control PTZ directions, step
length, zoom, focus, aperture, operating preset, point-to-point patrol, trace, boundary line scanning,
auxiliary switch, light switch, and horizontal rotation.
Note
1. Before operating, make sure the A/B cables of the dome are properly connected to the DVR
Page 19
To Next Page
Loading...
Need help?
General
