To Next PageTo Next PageWhat to do if RFGT high press fault appears on SMC Networks HRZ001-L?
If the pressure of the refrigerant circuit exceeded the specified value in your SMC Networks Chiller, check that facility water is being supplied to this system.
What to do if compressor overheat fault appears on SMC Networks Chiller?
If the temperature in the compressor of your SMC Networks Chiller was excessive, check that facility water is being supplied to this system.
What to do if FAN motor stop warning appears on SMC Networks HRZ001-L?
If the ventilating fan comes to a stop on your SMC Networks Chiller, check that the air vent on the back of the system is not blocked off.
What to do if reservoir high level warning appears on SMC Networks Chiller?
If you observe an excessive amount of circulating fluid in the tank of your SMC Networks Chiller, drain the circulating fluid.
What to do if return low flow fault appears on SMC Networks HRZ001-L?
If the flow rate of the circulating fluid falls short of 6L/min in your SMC Networks Chiller, ensure that the external valve is opened. Also, consider using a thicker external pipe or installing bypass piping.
What to do if return low flow warning appears on SMC Networks HRZ001-L?
If the flow rate of the circulating fluid falls short of your specified value in your SMC Networks Chiller, reset the setting flow rate.
What to do if reservoir low level fault appears on SMC Networks HRZ001-L?
If you observe an insufficient amount of circulating fluid in the tank of your SMC Networks Chiller, replenish the circulating fluid.
General| Brand | SMC Networks |
|---|---|
| Model | HRZ001-L |
| Category | Chiller |
| Language | English |
