SMC Networks ZSE30A(F) - Setting Display Resolution ([F4]); Adjusting Display Digit Precision

-31-
No.PS##-OML0003-B
■[F 4] Setting of display resolution
This function is to change the pressure display digit.
The flickering on the display can be eliminated.
<Operation>
Press the
or button in function selection mode to display [F 4].
Press the button. Move on to setting of display resolution.
Press the button to set. Return to function selection mode.
Setting of [F 4] display resolution completed
∗: Not selectable depending on selected pressure unit.
The display resolution selectable unit is MPa, kPa (for ZSE only), kgf/cm
2
, bar, psi and inHg.
The unit kgf/cm
2
, bar, psi and inHg are selectable when a unit conversion function is provided.
See [F 0] Unit conversion function on page 26.
Setting of display resolution
Press the
or
button to select display
resolution.