-17-
No.PS##-OML0003-B
■Piping
○Mounting by One-touch fitting
1. Cut the tube perpendicularly.
2. Hold the tube and insert it into the One-touch fitting slowly until it will bottom out.
Warning
■Do not use the Pressure switch in a place where electrical static charge will be problem.
It can cause the error and breakage of the system.
•Keep a margin for tube length to prevent twist, tensile and moment load from applying to the fitting and
tube.
•When using a tube manufactured by another company, check its outside diameter accuracy satisfies the
following value.
1) Nylon tube: ±0.1 mm at maximum
2) Soft nylon tube: ±0.1 mm at maximum
3) Polyurethane tube: +0.15 mm/-2 mm at maximum
To Next Page
Loading...
