-18-
No.PS##-OML0003-B
■Wiring
○Connection
•Connections should only be made with the power supply turned off.
•Use separate routes for the Pressure switch wiring and any power or high voltage wiring. Otherwise,
malfunction may result due to noise.
•Ensure that the FG terminal is connected to ground when using a commercially available switch-mode
power supply. When a switch-mode power supply is connected to the product, switching noise will be
superimposed and the product specification can no longer be met. This can be prevented by inserting a
noise filter, such as a line noise filter and ferrite core, between the switch-mode power supply and the
product, or by using a series power supply instead of a switch-mode power supply.
○Connector
Connecting/Disconnecting
•When mounting the connector, insert it straight into pins with holding the lever and connector body by
fingers and press fit the nook of the lever to the concave of the housing to lock.
•When removing the connector, press down the lever by thumb to let its nook come off from the concave
and pull out the connector straight.
Pin No. of the Connector
To Next Page
Loading...
