-56-
No.PS##-OML0003-B
○Error indication function
This function is to display error location and content when a problem or an error occurs.
Error Name Error Display Error Type Troubleshooting Method
Over current
Error
A load current of switch output is
80mA or more.
Turn the power off and remove the
output factor for the over current.
Then turn the power on.
Residual
Pressure Error
During zero clear operation, pressure
over ±7%F.S. (±3.5%F.S.for
compound pressure) is applied. After
1 s, the mode will reset to the
measurement mode. ±1%F.S. of the
zero clear range varies with
individual product differences.
Perform zero clear operation again
after restoring the applied pressure to
an atmospheric pressure condition.
Pressure has exceeded the upper
limit of the set pressure range.
Pressurizing Error
Pressure has exceeded the lower
limit of the set pressure range.
Reset applied pressure to a level
within the set pressure range.
System Error
Displayed in the case of an internal
data error.
Turn the power off and turn it on
again.
If resetting fails, an investigation by
SMC Corporation will be required.
If the error can not be reset after the above measures are taken, then please contact SMC.
To Next Page
Loading...
