Smeg SW262 - Page 34

34
ALARM ID
DESCRIPTION
USER ACTION
AF:56
Door lock fault, no automatic
open.
Make sure to close the door properly before running a wash
cycle.
Try opening the device again with the Open door button.
If necessary, use the manual door release procedure
described in this manual.
Run the DEFAULT PROCEDURE described above. If the alarm
does not reset, run the RESTORE PROCEDURE.
A:58
Dryer does not heat up. Only
model SWT260X.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESTORE PROCEDURE.
A:67
Dryer motor cooling cycle fault.
This cycle runs after drying to
restore the dry load and heating
elements to a safe temperature.
Only model SWT260X.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESTORE PROCEDURE.
AF:74
Acquastop device tripped (as
applicable).
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESTORE PROCEDURE.
AF:78
Restore fail. Motherboard error.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESTORE PROCEDURE.
AF:84
Dryer temperature higher than
setpoint. Only model SWT260X.
Wait for the automatic alarm handling procedure to
terminate.
A RESET cycle cannot be run while alarm AF:84 is being
handled by the system.
Do not disconnect power: automatic heating malfunction
handling in progress with heating element cooling cycle.
Only when this procedure has terminated may you run the
DEFAULT PROCEDURE described above.
A:93
Machine maintenance.
The machine has exceeded the set number of hours of
operation since installation or its last service: contact
technical service for routine maintenance.
Press Start/Pause to ignore the warning and continue using
the machine.
Run scheduled service as soon as possible to keep the
machine in good working order.
AF:96
Tank water level anomaly.
Check the water intake and drain fittings and that they are
compliant with specifications.
If you notice any leaks around the appliance, close all water
cocks.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESTORE PROCEDURE.
N.B.:
The drying system alarms (A 58, A 67) display at the end of the cycle, and reset when the door is opened.
If the messages persist, contact your local authorised service centre.