71/282
ENGLISH
Use and maintenance manual ßP700
2.5 POSITIONING AND LEVELLING
2.6 ADJUSTING THE CONNECTION BELT AND FASTENING
2.7 DEMOLITION AND DISPOSAL
ATTENTION!
The machine does not contain dangerous components or substances that
require particular removal procedures.
Regarding the elimination of the various materials, it is necessary to follow the
regulations of the Country in which the tunnel will be dismantled.
2.8 ELECTRICAL CONNECTIONS
All operations for the connection to the mains must be carried out with no
voltage applied to the machine.
In the case which someone wants access to the electrical system, remember to
turn off the power supply and wait at least 5 minutes before operating.
Fig. 2.5.1
Make sure that the floor, in the installation area,
does not present irregularities that may
prevent the normal and correct positioning of
the machine. After placing a level on the upper
part of the frame, level the machine using the
adjustable support feet then lock them by
tightening the locknuts.
Fig. 2.6.1
After levelling the belts and the shrink-
wrapping machine, position the machine's
connection belt as close as possible to that of
the tunnel.
The tunnel's belt must be 1 mm higher than the
shrink wrapping machine's belt to avoid the
pack from falling at the tunnel inlet. Adjust this
distance by working on the screws 1
1
To Next Page
Loading...