76/282
4. Preparation to the use of the machine
4.3 MANUAL SELECTION
Press [F3] and the following mode selection video page will appear on the
display.Press the push button [-] to position yourself on the selection >MANU< and
press [POWER] to confirm and then [ENTER] to go back to the main video page.
At this point the following push buttons are active:
[F1] - by pressing this push button you operate the sealing bar and the press with the
set time and sealing parameters.
[F2] - by pressing this push button you activate the feeding bar adjusted by the set pa-
rameters.
[
×] - by pressing this push button you activate the connection belt at a set time.
4.4 AUTOMATIC SELECTION
Press [F3] and the following mode selection video page will appear on the display.
Press the push button [+] to position yourself on the selection >AUTO< and press
[POWER] to confirm and then [ENTER] to go back to the main video page.
The working cycle "AUTO" allows the product to be packed using the two [START]
push buttons placed on the working surface, pressing them simultaneously.
If the two push buttons are released during the feeding progress this last goes back to
the loading position.
The machine operates with the parameters set in the menu [F3].
4.5 EMERGENCY PUSH-BUTTON
When the machine is stopped with the emergency button, all operations are suspended
and the cylinders go back to their starting position. To restore press the push-button
[POWER].
4.6 QUICK SELECTION OF THE PROGRAMS
The microprocessor allows us to store up to 6 different programs, automatic cycle
according to the size of the pack. The number of the program appears at the end of the
second line of the display.
Press the push button [ENTER] and then the keys [+] or [-] to modify the memory ( the
power is disabled automatically).
At this point confirm the position of the memory with [ENTER] and enable the power
again by pressing the push button [POWER].
To Next Page
Loading...