Smipack BP700 - Checking for Good Operating Conditions; Machine Limitations and Specifications of Use; Dangerous Areas

82/282
5. Machine use
According to the size of the product to be packed, the connection belt can accumulate
various packs. If the sealing bar's stroke is obstructed, the safety microswitch is
activated and all operations are interrupted and the cylinders return to their starting
position (to restore press [POWER]).
5.3 CHECKING FOR GOOD OPERATING CONDITIONS
1 • Belt section:
• Check the conveyor belts for possible damages.
• Check if the rollers are moving freely.
• Check that all the belts have a linear movement and that there are no breakages,
tearing or folds that can prevent the normal operation.
2 • Wrapping and film sealing section:
• Check the film tension.
• Check that there are no breakings on the sealing bar.
• Test the blade and check if there are broken or folded teeth (be very careful when
working near the blade, use protection gloves when handling ).
3 • Pneumatic section:
• Test the air pipes and check that there are no leakages.
• Check that the pipes are not disconnected from the fittings.
• Clean the filter on the air duct.
• Check that there is no water in the air filter.
5.4 MACHINE LIMITATIONS AND SPECIFICATIONS OF USE
The following cannot be packaged:
• Product with sizes higher than those permitted.
• Wet products.
• Inflammable products.
• Explosive products.
• Aerosol bombs of any kind.
• Loose powders and volatile products
ATTENTION!
It is not possible to pack anything that can in any way be dangerous to the user
and damage the machine itself.
5.5 DANGEROUS AREAS
• Do not touch the sealing bar immediately after a sealing going beyond the protection
barrier.
• Do not touch the film reel during the wrapping operation.
• Do not use the machine if there are any breakages to mechanical or electric
members.
• Do not use the machine with protections open or disconnected.