66 / 282
1. Regulations and general instructions
1.3 LEGAL REFERENCES
The machine "Film shrink-wrapper with sealing bar" complies to the Legislative
Provisions of the law that regulates the following Directives:
• MACHINE DIRECTIVE: 89/392/CEE, 91/368/CEE, 93/44/CEE, 93/68/CEE, 98/37/
CE.
• ELECTROMAGNETIC COMPATIBILITY DIRECTIVE: 89/336/CEE, 92/31/CEE,
and 93/97/CEE.
• LOW TENSION DIRECTIVE: 73/23CEE
The directives have been followed considering the agreed norms, including:
• EUROPEAN SAFETY REGULATION FOR MACHINERY:
EN 292/1 - EN 292/2 - EN 292/2/A1 - EN 294 - EN 349.
• ELECTRIC EQUIPMENT OF THE MACHINES: EN 60204-1.
• ASSEMBLED PROTECTION EQUIPMENT AND TRANSITION FOR LOW
TENSION (BOARD B.T.): EN 60439-1
1.4 REMARKS ON GENERAL SAFETY
The operator, before starting to work with this machine, must have acquired enough
knowledge on the location, function of the controls, characteristics of the machine, and
must have read this manual in all its entirety.
The employer must see to it that its personnel is informed on the following topics
relative to the safe usage of the machine:
• Accidents risks.
• Devices meant for the safety of the operator.
• General accidents prevention rules as provided by international directives and by
the laws of the country of destination of the machines.
It is necessary to comply to the following general precautions:
• Do not install the machine in areas posing a risk of explosion or fire.
• Do not temper with, remove or modify the safety devices; in such cases SMIPACK
S.p.A. declines any responsibility on the safety of its machines.
• Do not modify parts of the machine to install other devices without prior
authorization by SMIPACK S.p.A.; in case of unauthorized modifications the former
will not be held responsible for any possible consequences.
• Do not operate the machine in automatic mode with the fixed or mobile protections
removed.
• Do not open the fuse blocks with the mains on.
• Do not intervene on switches, valves and sensors without authorization.
• Do not intervene on the moving parts even without the aid of objects or tools.
• Do not manually oil or grease any moving part.
• Before carrying out any work on the electrical installation, ensure that the voltage
has been disconnected.
• After an adjustment or security operation, restore the state of the machine with
active protections.
ATTENTION!
The operator, the maintenance and cleaning personnel must scrupulously
To Next Page
Loading...
