Chapter 2 - Machine installation
18
• During assembly and disassembly avoid pushing the roller conveyor sideways in order not
to damage its couplings.
4) INSTALLATION OF THE SCRAP COLLECTION DEVICE
a) MOUNTING THE FILM SCRAP COLLECTION DEVICE
• Apply screws 1 on machine support B, being careful not to tighten them in order to facilitate
the subsequent operations. (stay at about 5 mm from the stop).
• Remove the protection guard 2 by undoing the screws 3.
• Position the device so that the upper side of support A comes into contact with support B,
surpassing the previously mounted screws by means of the wider holes. Then move the
device sideways in order to reach the final conditions shown in the figure and then fully
tighten the screws 1.
• Finally reassemble the protective casing 2.
To Next Page
Loading...
