5
Service
MAINTENANCE
TIRE PRESSURE
ENGINE
Service SJ or higher" SAE 30 oil� Use no special additives with recommended oils� Do not mix oil with gaso-
line�
SAE VISCOSITY GRADES
Starting Temperature Range Anticipated Before Next Oil Change 18-462-P
Use of multi-viscosity oils (10W-30, etc�) Above 80° F (27° C) will result in high oil consumption and possible
engine damage� Check oil level more frequently if using these types of oils�
SAE 30 oil, if used below 40° F (4° C), will result in hard starting and possible engine bore damage due to
inadequate lubrication�
HYDRAULIC OIL
1� Use SAE 10W-40 API Service SJ or higher motor oil�
3� The oil level should be 2" to 2
1
/
2
Check and service more frequently when operating in extremely cold, hot or dusty conditions�
cause�
9� In extreme temperatures you can use straight weight oil� We recommend SAE 30W API Service SJ or
higher when hot (above 90°F (33°C)) and SAE 10W API Service SJ or higher when cold (below 32°F
(0°C) ambient temperature� Use either motor oil or hydraulic oil, but do not mix�
10� Oil being added to the system must be the same as what is already in the tank�
which type you put in�
To Next Page
Loading...
