Copyright 12/14 10 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680 SAFETY PROCEDURES
SAFETY PROCEDURES
Never use jumper cables during freezing temperatures.
Tow the machine inside and allow the battery time to
warm up. Explosion will occur with a frozen battery.
Never use jumper cables in a confined or unventilated
area. Battery acid fumes are explosive. Battery acid
can cause severe burns. Avoid contact with eyes, skin
and clothing. Battery fumes are flammable and can
explode. Never expose an open flame or spark near the
battery. Keep all burning materials away from the
battery. When servicing the battery, do not smoke, shield
eyes and face. Service in a well ventilated area.
DO NOT GO NEAR HYDRAULIC LEAKS! High
pressure oil easily punctures skin causing serious
injury, gangrene, or death. DO NOT use fingers or skin
to check for leaks. Lower load or relieve hydraulic
pressure before loosening fittings. Use a piece of
cardboard to find leaks. Never use your bare hands.
In cold weather situations let your hydraulic system
idle for approximately 15 minutes to allow the system
to warm up to operating temperature. Avoid burns from
fluid. Hot fluid under pressure can cause severe burns.
Relieve all pressure in the system before disconnecting
the lines, hoses or performing other work. Allow
system to cool down to ambient temperature before
opening any coolant or hydraulic oil system.
Inspect raw materials pile for prohibited materials. The
following are examples of prohibited materials to be
avoided. Material and products containing toxic
substances, explosive or flammable materials
including chemicals, liquids, gases, pressurized
containers etc., tires, glass, heavy rigid plastic, sheet
metal, masonry, stone materials, and solid metals.
DO NOT operate this machine indoors! Exhaust
fumes can be fatal. Never refuel while the machine is
running or engine is hot. Never refuel in the shop or
building. Always refuel in a well ventilated area, away
from sparks or open flames, DO NOT SMOKE.
Extinguish all smoking materials. Wipe up all spilled
fuel before restarting the engine. Do not fill above 1/2”
(12.7 mm) from top of tank.
To obtain the most from the recycler, for the least
amount of cost, it is a good practice to set and follow a
scheduled preventative maintenance program. It will
eliminate many possible problems and down time.
Check laws and regulations. Know and obey all
federal, state, and local laws and regulations that apply
to your work situation and the transportation of a
machine this size.
Keep the machine in good condition. Be sure the
machine is in good operating condition and that all safety
devices, including guards and shields are installed and
functioning properly. Visually inspect the machine daily
before starting the machine. Refer to the “Start-up
Procedures “. Make no modifications to your equipment
unless specifically recommended or requested by
Smoracy, LLC.
Avoid power lines. Electrocution is possible if the
recycler touches a power line. Take the following
precautions. Position the recycler and any loading
equipment at least 10 feet (3 meters) from electric lines.
If the machine contacts an electric line stay away from
the machine.
After engine is started, let the Cutterhead turn at the
lowest RPM’s possible. Listen for any type of noise
that is foreign. Any steel against steel noise is
foreign. If you hear a noise, stop the engine and find the
problem.
The machine was built with a maintenance door
engine disable plug which disables the engine if it is not
installed properly with the maintenance in the closed
position. Correctly installed and maintained, the engine
will not start or it will shut off if the maintenance door
engine disable plug is disconnected. The maintenance
door must NEVER be open or opened during operation.
WARNING
DANGER
DANGER
DANGER
WARNING
DANGER
WARNING
WARNING
WARNNG
To Next Page
Loading...