Copyright 12/14 9 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680
Never stand at the entrance to the Infeed Conveyor or
look over the Infeed Conveyor side panels. Never
attempt to manually dislodge material located on the
Infeed Conveyor while the machine is running. Never
raise Feedwheel Yoke and look inside, or look down
Infeed Conveyor while machine is working.
Entanglement in Infeed Conveyor can cause serious
injury. Stay away from the Infeed Conveyor during
operation. If the conveyor drive is not shut off a stalled
conveyor may restart unexpectedly as the obstruction
is removed. Do not hand feed raw material onto Infeed
Conveyor.
Avoid moving parts. Keep hands, feet, and clothing
away from power driven parts. Keep all guards and
shields in place and properly secured.
Stay away from the Feedwheel and Cutterhead
areas. Never stand close to the Feedwheel assembly
while the machine is running. Never attempt to do work
on a raised Feedwheel without making sure all safety
devices are secured. Always engage the hydraulic Yoke
Lock Bars, and use the Safety Chain to secure the
Feedwheel assembly to the Discharge Belt Conveyor
rest before replacing Cutterhead inserts or bodies.
Follow proper shutdown procedures before beginning
any type of maintenance to the Recycler.
Entanglement in the Discharge Belt Conveyor can
cause serious injury. Stay away from the conveyor
during operation. If the conveyor drive is not shut off a
stalled conveyor may restart unexpectedly as the
obstruction is removed. Avoid the Discharge Belt
Conveyor area. Ejected material can cause serious
injury. Stay away! Stay clear of thrown and falling
objects. Take the following precautions to avoid
injuries from thrown and falling objects: Wear all
applicable safety equipment. Only properly protected
workers are allowed in “thrown object area”. All
machines in “thrown object area” must have overhead
protection. Machines used to load the recycler must
have an enclosed cab. Do not leave controls unattended
while machine is operating. Locate the recycler a safe
distance from buildings, public roads and populated
areas.
NEVER sit, stand, lay, climb or ride anywhere
on this machine while it is running, operating, or in
transit. You will be injured.
To avoid damage to the Discharge Conveyor do not
move the machine with the Conveyor extended. Do not
fold or unfold the Conveyor on uneven ground. Do not
cause abrupt stops when raising or lowering the
Conveyor. Do follow all operation, service and safety
guidelines. Do follow these steps to purge air from the
hydraulic system every time the Conveyor is moved.
1) Place pressure gauge in diagnostic port of valve bank.
2) With Conveyor resting in fold or unfold position,
operate valve to position it further in that direction. Hold
valve position for 4 to 5 seconds until gauge reaches
system pressure. 3) Repeat these steps for second
control valve. Now you may proceed to raise or lower
the Conveyor. Do operate the Conveyor folding actions
with the engine at idle. Do fold the Conveyor upper
section first, then the mid section. NEVER slam the
Discharge Belt Conveyor to a rest.
It is very important after you have operated a new
machine for approximately an hour, shut down the
machine and recheck all nuts and bolts. It is normal for
bolts to loosen once on a new piece of machinery. If
you tighten them now, there is a good possibility they
won’t loosen again. Certain bolts should be checked
periodically such as Cutterbody and Teeth bolts, etc.
for torque and fit.
Most of the nuts used on the Smoracy, LLC
Recycler are self locking. After a nut has been removed
five times, it should be replaced to insure proper
tightness.
SAFETY PROCEDURES
SAFETY PROCEDURES
DANGER
DANGER
DANGER
NOTICE
DANGER
DANGER
WARNING
To Next Page
Loading...