SMORACY BEAST 3680 - Page 23

Copyright 12/14 21 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680
AUTO FEED OPTIONS
NOTICE
Before you begin programming, you will need to determine the appropriate numbers (values) to use for the following
settings:
HI RPM:
This is the RPM at which the controller will turn OFF.
LO RPM:
This is the RPM at which the controller turns ON.
BACKUP TIME:
This is the time, in milliseconds, to allow the feed system to reverse.
PROGRAMMING SEQUENCE
1) Turning On Program Mode:
While The Engine Is Off:
Press and hold the set button while turning ignition key ON. Release button. Go To Step #2
While The Engine Is Running:
Press and hold the set button for 2 to 3 seconds. Release Button. Go To Step #2
NOTE:
To advance from one setting to the next (while engine is running) you must
PRESS & HOLD the SET button until the screen changes.
2) Set the HI RPM Value:
To decrease the setting value press the button.
To increase the setting value press the button.
To save the setting press the button. The set button initiates
the program mode, saves settings, and finalizes the program mode.
3) Set the LOW RPM Value:
To decrease the setting value press the button.
To increase the setting value press the button.
To save the setting press the button. The set button initiates
the program mode, saves settings, and finalizes the program mode.
down
up
set
down
up
set
AUTOFEED SECTION