SMORACY BEAST 3680

To Next Page

To Previous Page

Smoracy, LLC

MODEL 3680

OPERATING THE

RADIO REMOTE

In order to operate the Recycler using the Radio Remote controls, the manual control valves must

all be placed in the off position.

On/Off Switch (1)

To turn on the remote control push the switch up. To turn off the remote control push the switch

down.

Feedwheel Yoke Raise and All Feed Reverse Switch (2)

To raise the Feedwheel Yoke push the switch up. Letting the switch return to center allows the

Feedwheel to lower and float on incoming material. Pulling the switch down allows the Infeed Conveyor

Chain and Feedwheel to reverse at the same time. To start the Infeed Conveyor Chain and Feedwheel

again you will need to push up on the individual switches.

Throttle Switch (3)

To throttle up the engine push the switch up. To throttle down the engine push the switch down.

Engine Shut Down Button (4)

To shut the engine down press the engine kill switch. This will not stop everything immediately. Allow

any moving parts to come to a complete stop. The Key switch will need to be cycled to allow the

engine to restart.

Feedwheel Control Switch (5)

To have the Feedwheel run in the forward motion the switch needs to be pushed up. To have the

Feedwheel turn in the reverse motion the switch needs to be pushed down.

Concave Door Control Switch (6)

To have the Concave Door open push the switch up. To have the Concave Door close push the

switch down.

Infeed Conveyor Control Switch (7)

To have the chain run in the forward motion the switch needs to be pushed up. To have the chain run

in the reverse motion the switch needs to be pushed down.

The Monitor Light (8)

The light will be green when the remote control is turned on. The light will not be lit when the remote

is turned off.

CONTROLS

SMORACY BEAST 3680 - Page 31