Copyright 12/14 33 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680
LIGHTING 12-volt, heavy-duty tail light package with hermetically sealed LED lights, enclosed in
ELECTRICAL heavy-duty durable plastic housing. (24-volt available)
SYSTEM:
FEED Horizontal feed, hydraulically powered 20 feet (6.1 m) long by 5 feet (1.5 m) wide
SYSTEM: angle type slatconveyor, assisted with a 24 inch (610 mm) diameter by 5 feet (1.5 m)
wide floating feedwheel mounted over the conveyor. Total pulling capacity: 7-1/2 tons
(6804 kg).
DISCHARGE 4 feet (1.2 m) wide x 30 feet (9.1 m)long, fold-up belt conveyor with vee-style cleats,
CONVEYOR: troughing rolls, 2 speed constant hydraulic direct drive and optional magnetic head.
Discharge height: 17 feet - 3 inches (5.3 m) approximate
Operating speed: (Slow) Approx. 350 feet/min (106.7 m/min)
(Fast) Approx. 800 feet/min (243.8 m/min)
CUTTER MILL:Consists of 60 cutters mounted between supports welded to 24” (610 mm) diameter
drum. Tip to tip diameter is 42” (1067 mm). Head width is 63” (1600 mm). Cutters
consists of body, plus bolt and lock nut, and cutter insert and nut.
MAIN CUTTER (2) - 4 15/16” (125 mm) diameter spherical roller pillow block bearings.
HEAD
BEARING:
SCREENS: Various screen options available.
INFEED
CONVEYOR Three speed infeed conveyor chain.
SPEED RATE: Approximately 10, 20, and 30 Feet/Min. (3.0, 6.1, and 9.1 Meter/Min.)
CUTTER 6” (152 mm) or 7” (178 mm) diameter, bushing mounted inside 24” (610 mm) diameter
HEAD by 3/4” (19.1 mm) wall pipe connectedby end plates. (Depending on engine options)
SHAFT:
CUTTER MILL 30” (762 mm) high x 60” (1524 mm) wide
OPENING:
GUARDS: All rotating parts covered by heavy-duty guards.
OVERALL Approximately 36’ (11.0 m) long x 8’6” (2.6 m) wide x 13’3” (4.0 m) high.
DIMENSIONS:
EQUIPMENT SPECIFICATIONS
EQUIPMENT SPECIFICATIONS
To Next Page
Loading...