Copyright 12/14 34 S/N XXXX WO#XXXXXX
Smoracy, LLC
MODEL 3680
SPECIFICATIONS - FOR MODEL 3680 BEAST (Continued)
WEIGHT: Approximately 62,000 pounds (28,122 kg). (Depending on engine options.)
MACHINE Primary control with electric Tether Remote. Secondary Control with radio remote
SYSTEM control option. Manual hydraulic controls for maintenance purposes.
CONTROLS:
HYDRAULIC Protected by hose guards in all wear areas.
HOSES:
RADIATOR High capacity radiator debris screen.
SCREEN:
ENGINES: Optional engines available between 400 and 650 H.P. range.
BATTERY Lockable, steel fabricated construction.
BOX:
HYDRAULIC Hydraulic pumps will vary depending on engine options.
PUMPS:
All welding is done by an experienced labor force, using gas MIG welders. They are inspected and
reinspected to assure secure, solid welds. Many fabricated components such as drive guards, cutter
head base, etc. are not only externally welded but internally welded as well. This type of quality work
insures good looks as well as security.
The CLUTCH is a relatively expensive wear item on the
recycler. This decal is installed on each machine
shipped as a reminder to the operator to save money
and down time by proper maintenance and usage.
Refer to your clutch manuals for proper maintenance
procedures.
Please remember, if it ISN’T taking most of your strength
to engage the clutch, IT ISN’T ADJUSTED PROPERLY.
SMORACY, LLC DOES NOT warranty clutch
failures. Warranty must be handled through the
respective manufacturers.
New clutches require several adjustments in the first
few hours of operation. This is the time period they are
wearing in. Failure to adjust will cause the entire clutch
to burn up.
EQUIPMENT SPECIFICATIONS
THE CLUTCH HANDLE SHOULD NOT
BE ENGAGED OR DISENGAGED AT
SPEEDS ABOVE 1000 RPM’S.
DO NOT operate this Clutch/PTO unless proper adjustments and lubri-
cation are maintained per the Clutch/PTO Manufacturer’s Manual.
Different brands and models require different service and operation
procedures. New Clutch/PTO’s require more
frequent adjustment.
GOOD OPERATORS
DON’T WASTE MONEY!
Clutches will fail, glaze over, and burn up from
improper adjustment. This will cost the owner of this
machine thousands of dollars to repair. A well main-
tained, correctly adjusted clutch should function properly
for years.
NOTICE
To Next Page
Loading...