Digital Wireless Video Scope
5
Snap-on
Technical questions can be directed to our toll free
number at 1-877-765-7665 Monday through Friday
6:30 am to 5:00 pm Central Time (U.S. customers
only).
Specific Safety Information
Read this operator's manual carefully before using.
Failure to understand and follow the contents of this
manual may result in electrical shock, fire and/or se-
vere personal injury.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the fol lowing two conditions:
1. This device may not cause harmful inter ference.
2. This device must accept any interfer ence
received, including interference that may cause
undesired operation. NOTE! This equipment
has been tested and found to comply with
the limits for Class A digital devices, pursu-
ant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equip ment generates uses
and can radiate radio frequency energy and, if
not in stalled and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that in terference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be de termined by turning
the equipment off and on, the user is encour-
aged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equip-
ment and receiver.
– Consult the dealer for help.
Use of shielded cable is required to comply with
Class A limits in Subpart B of Part 15 of the FCC
rules.
Do not make any changes or modifications to the
equipment.
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harm-
ful interference, and (2) This device must accept
any interference received, including reference that
may cause undesired operation. Note: Changes
or modification not expressly approved by the party
responsible for compliance could void the user's au-
thority to operate the equipment.
This Class A digital device complies with Canadian
ICES-003.
Video Scope Safety
• Donotplacetoolintoanythingoranywherethat
may contain a live electrical charge.
• FOR WALLS: For inspecting inside walls, be
sure to shut off the circuit breaker to the whole
house before using the tool behind any of the
walls
• FORPIPES:Ifyoususpectametalpipecould
contain an electrical charge, have a qualied
electrician check the pipe before using the
tool. Ground cir cuits, in some cases, can be
returned to cast iron pipes and cause them to
be charged.
• FOR AUTOMOBILES/HEAVY EQUIPMENT/
MOTORSPORTS: Be sure the auto mobile,
heavy equipment or motorsport equipment is
not running during inspection. Metal and liquid
under the hood may be hot. Do not get oil or gas
on the imager head. Exposure to petroleum-
based sub stances will eventually degrade the
im ager head covering.
• GENERALUSE:Donotuseanywheretheunit
may come into exposure with haz ardous chemi-
cals, electrical charges or moving parts. Such
situations may result in serious injury or death.
SAVE THESE INSTRUCTIONS!
To Next Page
Loading...
Need help?
General
