Using the Phone
forwarding when busy; if there is no setting for call forwarding, callers will hear the busy signal.
Exception: Phone numbers designated VIP in your phone's directory will ring on your phone even
when DND is on.
1. Press
to activate DND.
2. Press
again to deactive DND.
• Call forwarding. For further information, see "Call forwarding" on page 55 and 70.
Rejecting anonymous calls
With this setting you can make your phone reject calls from phones that are blocking or not transmitting
their numbers.
Please note: Calls from analog phone connections without caller ID will, most likely, be
received as anonymous calls. They will be rejected if you turn this function on.
Activating rejection of anonymous calls:
1. Press
.
2. Press 2 Call Features.
3. Press 3 Incoming Calls.
4. Press 1 to change setting "1 Reject anonymous" from [No] to [Yes].
5. Press
for two seconds to return to the idle screen.
Deactivating rejection of anonymous calls:
1. Press
.
2. Press 2 Call Features.
3. Press 3 Incoming Calls.
4. Press 1 to change setting "1 Reject anonymous" from [Yes] to [No].
5. Press
for two seconds to return to the idle screen.
Call forwarding
The phone can be set to forward incoming calls, either always or under certain conditions. The settings
can be done on the phone and on the web interface. For further information on using the web interface
for these settings, see "Call forwarding" on page 70.
Forward All: Forwarding all incoming calls to the number of the phone, extension, or mailbox
specified as this function’s target.
As the default setting, the function key
in the function key line turns forwarding of all calls on and
off, but you can also map the function onto another function key or use the settings menu as shown in
the table, below.
To Next Page
Loading...
