socomec OFYS RT - ELECTRICAL INSTALLATION; CONNECTIONS

OFYS RT 1 - 3kVA - 551906A - SOCOMEC
12 EN
5. ELECTRICAL INSTALLATION
NOTE!
Before carrying out any operations on the unit read the ‘Safety standards’ chapter carefully.
The installer is responsible for ensuring that the battery installation and their operating environment conform to
national and international codes and safety standards.
5.1. Electrical requirements
Since OFYS is a pluggable equipment type A, the protective device is provided in the installation and shall not
require any specic characteristics other than that required in IEC 60364 or other local installation codes.
6. CONNECTIONS
NOTE!
Before carrying out any operations on the unit read the ‘Safety standards’ chapter carefully.
WARNING!
Make sure the UPS is not turned on before installation.
The UPS should not be turned on during wiring connection.
Turn off battery breaker before installation if any.
NOTE!
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords.
1000VA