Need help?Do you have a question about the socomec DELPHYS MX and is the answer not in the manual?
General| Topology | Double Conversion Online |
|---|---|
| Output Voltage | 400 V (3Ph+N) ±1% |
| Efficiency | Up to 96% |
| Battery Type | Valve Regulated Lead Acid (VRLA) |
| Communication Interfaces | RS232, USB, SNMP, Modbus |
| Frequency Range | 50/60 Hz |
| Operating Temperature | 0°C to 40°C |
| Relative Humidity | 0 to 95% non-condensing |
| Dimensions | Varies by model, consult datasheet |
| Weight | Varies by model, consult datasheet |
Utilizes function 3 for reading input registers and function 6 for writing single registers.
Check cabling before making any connection to prevent damage to the serial link interface.
Default settings for serial link 1 and 2: 9600 baud, NONE parity, 8 data bits, 1 stop bit, slave 1.
How to change baud rate, parity, and slave number via control panel or graphic touch screen.
Protocol is slave and RTU mode, using function 3 (read) and 6 (write). Slave number set via panel.
Details the UPS Identification table, including UPS code, power, module number, and serial number.
Covers UPS configuration parameters like input/output voltage, frequency, version, and battery capacity.
Details various alarm codes (A00-A63), their addresses, and descriptions.
Lists measurement parameters (M00-M47) with their codes, units, addresses, and remarks.
Lists controls that can be enabled on the UPS, specified by code and address.
Details controls available via JBUS/MODBUS, including value to write and address.
Details alarm codes and their availability on AC, Module, or Unit from address 0x40.
Lists measurement parameters and their addresses available on the common bypass (CC) from address 0x60.
To Next Page
