Need help?Do you have a question about the socomec STATYS and is the answer not in the manual?
General| Frequency | 50 / 60 Hz |
|---|---|
| Type | Automatic Transfer Switch |
| Rated Current | 16A to 3200A |
| Number of Poles | 3, 4 |
| Switching Time | < 2 ms |
| Transfer Time | < 2 ms |
| Communication | Ethernet, Modbus |
| Standards | IEC 60947-6-1 |
| Technology | Static switch (Solid state) |
Ensure proper operating conditions for the JBUS/MODBUS interface.
Follow specific operating instructions and safety guidelines for STATYS.
Guidelines for responsible disposal and recycling of electrical components.
Overview of the document's purpose and the JBUS/MODBUS serial link.
Information on the JBUS/MODBUS protocol functions and data composition.
Explains how status, alarms, and measurement data are encoded.
Locating the available communication slots for interface installation.
Step-by-step guide for physically installing the serial interface.
Detailed instructions for RS232, RS485, and RS422 connections.
Default communication parameters for serial links 1 and 2.
Procedures to modify baud rate, parity, and slave number.
Details on JBUS/MODBUS slave mode, RTU, and frame error management.
Guidance on reading and interpreting JBUS/MODBUS data tables.
Format and structure of data received via the serial link.
Mapping of system states to specific bits and addresses.
List of alarm codes, descriptions, and their corresponding addresses.
Comprehensive list of system measurements, units, and addresses.
Table defining system access permissions for various operations.
Table detailing commands to control STATYS system parameters.
To Next Page
