SOFAR 1~4KTL2-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
Figure 4-6 Connecting DC input power cables
1.Positive power cable 2.Negative power cable
Step 5 Insert crimped power cables into corresponding housings
until you hear a "click" sound. The power cables snap into place.
Step 6 Reinstall cable glands on positive and negative connectors
and rotate them against the insulation covers.
Step 7 Insert the positive and negative connectors into
corresponding DC input terminals of the inverter until you hear a
"click" sound, as shown in Figure 4-7.
Figure 4-7 Connecting DC input power cables
1.Bayonet
Note:
Insert the stoppers into the unused DC connectors.
Follow-up Procedure
To remove the positive and negative connectors from the inverter,
insert a removal wrench into the bayonet and press the wrench
with an appropriate strength, as shown in Figure 4-8.
To Next Page
Loading...
