The DRM parameters are described in the following table.
Parameter Name Setting Instructions
DRM enable
General enable switch, all DRM functions do not
take effect when off
DRM0 enable
DRM0 enable switch to turn on or off the function
of DRM0.
DRM5 limit power value
Percentage of inverter generating power limit
when DRM5 is in effect
DRM6 limit power value
Percentage of inverter generating power limit
when DRM6 is in effect
DRM7 limit power value
Percentage of inverter generating power limit
when DRM7 is in effect
DRM8 limit power value
Percentage of inverter generating power limit
when DRM8 is in effect
2. 2. Inverter device control
Click “Device Control” under “
” in the upper right corner of the inverter detail
page to enter the inverter remote control page. Users can set the remote pow-
er on/off, power control, restore factory settings, input channel, system time
and so on.
3. 3. Meter device control
Click “Device Control” under “
” in the upper right corner of the meter device
details page to enter the meter remote control page. Users can set CT ratio and
other settings for the meter.
8.3.7. Operation Log8.3.7. Operation Log
After entering the plant, click “Device”, and then click the SN of the corre-
sponding device to enter the device details page. Click “Operation log” under”
under “ ” in the upper right corner to enter the operation log page, and you
can view all the operation records of the device.
8.3.8. Device Upgrade8.3.8. Device Upgrade
After entering the plant, click “Device”, click the SN of the device you want to
upgrade to enter the detail page of the device. Click “Device Upgrade” under“
” in the upper right corner to enter the device upgrade page. Select the
firmware you want to upgrade and click Upgrade. Take the CH1000 device
upgrade as an example, as shown in the following figure.
82/92 SOFAR CH1000
SOFAR Cloud /APP Operation
To Next Page
Loading...