3. 3. Meter device details
After entering the plant, click on “Device”. By clicking on the SN of the meter,
users can enter the meter device details to view basic information such as
meter device name and model, as well as real-time information such as grid
frequency, phase voltage, phase current and phase power.
8.3.6. Device Control8.3.6. Device Control
1. 1. CH1000 device control
After entering the plant, click “Device”, and then click the SN of CH1000, users
will enter the CH1000 device details page. Click “Device Control” under “
” in
the upper right corner of the CH1000 device details page to enter the CH1000
remote control page, as shown in the following figure. On the advanced
settings page, users can set DRM and feed-in limitation settings for CH1000.
On the system settings page, users can set the system time, priority Internet
access, 4G, Ethernet and so on.
The feed-in limitation parameters are described in the table below.
Parameter Name Setting Instructions
Enable Enable or disable feed-in limitation
Mode
Setting the mode of feed-in limitation control, only
total power control is supported
Limit power value Setting the power limit value for feed-in limitation
Installation and User Manual 81/92
SOFAR Cloud /APP Operation
To Next Page
Loading...