SolarEdge Inline Energy Meter

Chapter 3: Configuration
SolarEdge Device Firmware Version
To ensure proper communication with the inline meter, make sure that the inverter
communication board firmware (CPU) version is up-to-date.
NOTE
If the inverter uses an earlier firmware version, it will automatically upgrade the CPU
to the required version upon connection of the inverter to SetApp. In the event that
an upgrade is required, open SetApp, making sure that your smart phone has an
Internet connection. This will enable it to download the most up-to-date CPU version.
To check the inverter CPU version using SetApp:
1.
Select Commissioning è Information to view the CPU Version.
Information
CPUVersion 4.13.xx

DSP1 Version 1.0210.1066

DSP2 Version 2.0052.0410

Serial Number 7Fxxxxxx-yy

Hardware IDs 
›
Error Log 
›
Warning Log 
›


Inline Energy Meter with SolarEdge Energy Net Communications
26 Chapter 3: Configuration