Device Configuration
This section describes basic configuration of SolarEdge inverters for use of the inline
meter. In addition, a configuration that is specific to the application being used is
required in some cases. Refer to the following documents:
Export Limitation - https://www.solaredge.com/sites/default/files/feed-in_
limitation_application_note.pdf
To configure two connected meters, refer to
Installing Multiple Meters
on page 39.
NOTE
Calculated meter readings, such as self-consumption, are calculated using the
data measured by the inline meter and the inverters. Calculated meter
readings are only sent when Energy Manager is enabled (for details refer to:
https://www.solaredge.com/sites/default/files/feed-in_limitation_application_
note.pdf).
Chapter 3: Configuration 27
Inline Energy Meter with SolarEdge Energy Net Communications
To Next Page
Loading...
