85DR-C
74
MODEM Use IRQ Name the interrupt request (IRQ) line assigned to
the modem (if any) on your system. Activity of the
selected IRQ always awakens the system.
The choices: 3 (default); 4; 5; 7; 9; 10; 11; NA.
Video Off in Suspend This determines the manner in which the monitor is
blanked.
The choices: Yes(default); No.
Suspend Type Select the Suspend Type.
The choices: PWRON Suspend; StopGrant (default).
Video Off Method This determines the manner by which the monitor is
blanked. Default: V/H Sync+Blank
V/H SYNC + Blank
DPMS Supports
Blank Screen
This selection will cause the system to turn off the vertical
and horizontal synchronization ports and write blanks to the
video buffer.
This option only writes blanks to the video buffer.
Select this option if you monitor supports the Display Power
Management Signaling (DPMS) standard of the Video Elect-
ronics Standards to select video power management values.
Power Management This option allows you to select the type (or degree)
of power saving for Doze, Standby, and Suspend
modes.
This table describes each power management
mode. Default: User Define.
Max Saving
User Define
Min Saving
Maximum power savings. Only Available for SL CPUs.
Inactivity period is 1 minute in each mode.
Set each mode individually. Select time-out period in
the section for each mode stated below.
Minimum power savings. Inactivity period is 1 hour in
each mode (except the hard drive).
To Next Page
Loading...
