MEASURING MESSAGES
CAUTION!
Connecting the input terminals to voltages above 600V may cause damage to the meter
and the risk of electrical injury to the user.
Test voltage is present on terminals of the meter.
You must consult the manual.
The meter is ready for measurement.
Indicates noise in the system during the measurement.
The measurement result may be affected by additional uncertainty.
Activation of current limit. The symbol displayed is accompanied
by a continuous audio signal.
Leakage current too high (breakdown of insulation during the measurement).
LED is lit in red,
two-tone acoustic signal
The tested object is live. The measurement is blocked.
Discharging of the object tested after the measurement.
The temperature inside the meter has risen above the allowable limit, the
measurement is blocked.
Resistance compensation is active.
Nominal voltage V
ISO
is higher than 500V while WS-04 adapter is connected.
The measurement is blocked.
The charge level of the batteries:
Batteries/ rechargeable batteries charged.
Batteries / rechargeable batteries almost discharged.
Batteries / rechargeable batteries fully discharged.
To Next Page
Loading...
