Sony DCR-HC39E - Switch Check (2); Switch Check (3); Switch Check (4)

6-65
DCR-HC39E/HC41/HC42/HC42E/HC43/HC43E
9. Switch Check (4)
Page 7 Address 65 to 6B
Note: Check that the data of page: 0, address: 10 is “00”.
Using method:
1) Select page: 7, address: 65 to 6B.
2) By discriminating the display data, the pressed key can be discriminated.
Address
65
(KEY AD0)
(IC5102 <zc. )
66
(KEY AD1)
(IC5102 <zv/ )
67
(KEY AD2)
(IC5102 <zvz )
68
(KEY AD3)
(IC5102 <zvx )
69
(KEY AD4)
(IC5102 <zvc )
6A
(KEY AD5)
(IC5102 <zvv )
6B
(KEY AD6)
(IC5102 <zvb )
00 to 0C
START/STOP
(SS10300 block)
(S004)
2nd
START/STOP
(SB10600 block)
(S001)
PHOTO
(REC)
(SS10300 block)
(S002)
EASY
(FP-187 flexible)
(S002)
0D to 26
ZOOM W
(SB10600 block)
(S002)
BACK LIGHT
(FP-187 flexible)
(S003)
27 to 43
ZOOM T
(SB10600 block)
(S003)
PHOTO
(FREEZE)
(SS10300 block)
(S003)
PANEL
CLOSE
(FP-187 flexible)
(S004)
44 to 63
WIDE
(SB10600 block)
(S004)
64 to 8A
PANEL
REVERES
(FP-186 flexible)
(S001)
8B to B6 B7 to E6 E7 to FF
No key input
PANEL
NORMAL
(FP-186 flexible)
(S001)
No key input
PANEL
OPEN
(FP-187 flexible)
(S004)
Data
7. Switch Check (2)
Page 7 Address 0F
Using method:
1) Select page: 7, address: 0F.
2) By discriminating the bit value of display data, the state of switch can be discriminated.
8. Switch Check (3)
Page 7 Address F4
Using method:
1) Select page: 7, address: F4.
2) By discriminating the bit value of display data, the state of switch can be discriminated.
Bit Function When bit value = 1 When bit value = 0
2 Lens cover (SI-042 board S601) Close Open
Bit Function When bit value = 1 When bit value = 0
4 REC PROOF SW (Mechanism chassis) SAVE REC