83
Troubleshooting
Date Search does not work correctly.
• Be sure to record more than 2 minutes after the date changed. If one day’s recording is too
short, your camcorder may not accurately find the point where the recording date changes.
• There is a blank section between recorded sections of the tape. This is not a malfunction.
New sound added to a recorded tape on another camcorder is not heard.
• Change the [DV AUDIO MIX] setting from [ST1] (original sound) to [MIX] or [ST2].
appears on the LCD screen.
• appears when you play back a tape recorded on another device using a 4ch
microphone (4CH MIC REC). This camcorder does not comply with the 4ch microphone
recording standard.
Pictures from connected devices cannot be zoomed.
• You cannot zoom pictures from connected devices on your camcorder (p. 24).
Time code and other information appear on the display of the connected
device.
• Set [DISP OUTPUT] to [LCD PANEL] while connected with an A/V connecting cable
(
p. 66).
You cannot dub correctly using the A/V connecting cable.
• The A/V connecting cable is not connected properly.
Make sure that the A/V connecting cable is connected to the input jack of the other device for
dubbing a picture from your camcorder.
You cannot add sound to the recorded tape.
• You cannot add sound to the recorded tape on this unit.
Still pictures cannot be dubbed from a tape to a “Memory Stick Duo” media.
• You cannot capture pictures at all or good-quality pictures from the tape that has been used
repeatedly for recording.
When you copy a movie shot in wide (16:9) format using an i.LINK cable, the
screen stretches vertically.
• You cannot output the aspect ratio setting using an i.LINK cable. Set the aspect ratio of the
TV instead.
• Connect using an A/V connecting cable instead.
Dubbing/Editing/Connecting to other devices
Continued ,
To Next Page
Loading...
