DHC-AZ55D/AZ33D.GB.3-215-548-11(1)
108
GB
Additional Information
Troubleshooting
Should you encounter a problem with
your system, do the following:
1
Make sure the power cord and
speaker cords are connected
correctly and rmly.
2
Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists aer doing all
of the above, consult your nearest Sony
dealer.
If the STANDBY indicator ashes
Immediately unplug the power cord,
and check the following items.
Are you using only the supplied
speakers?
Are the + and speaker cords
short-circuited? (DHC-AZ55D
only)
Is anything blocking the ventilation
holes on the rear of the system?
Aer the STANDBY indicator
stops ashing, reconnect the power
cord, and turn on the system. If the
issue persists, contact your nearest
Sony dealer.
General
The display starts ashing as soon
as you plug in the power cord even
though you have not turned on the
system.
Press DISPLAY
once while the
system is o. e demonstration
disappears.
“– –:– –” appears in the display.
A power failure has occurred. Set the
clock (page 29) and timer settings
(page 97) again.
The touch sensors on the front panel
do not function.
Unplug and reconnect the power cord.
The system does not turn on.
Is the power cord plugged in?
Is the voltage selector set correctly to
match the local power line voltage?
The clock or timer setting is canceled.
e power cord is disconnected or a
power failure occurred. Redo “Setting
the clock” (page 29). If you have set
the timer, redo “Using the timer” (page
97).
To Next Page
Loading...
Need help?
General
